Influence of rounded corners on flow interference between two tandem cylinders using FVM and IB-LBM

Purpose: The purpose of this study is to numerically investigate the influence of corner radius on the flow around two square cylinders in tandem arrangements at a Reynolds number of 100. Design/methodology/approach: Six models of square cylinders with corner radii R/D = 0.0, 0.1, 0.2, 0.3, 0.4 and 0.5 (where R denotes the corner radius and D denotes the characteristic dimension of the body) were studied using an immersed boundary-lattice Boltzmann method, and the results were compared with those obtained using a two-dimensional unsteady finite volume method. The cylinders were mounted in a tandem configuration (1.5 ≤ L/D ≤ 10 where L denotes the in-line separation between the cylinder centers). The simulated models were quantitatively compared to the aerodynamic force coefficients and Strouhal number. Furthermore, qualitative analysis is presented in the form of flow streamlines and vorticity contours. Findings: The R/D and L/D values were varied to observe the variation in the flow characteristics in the gap and wake regions. The numerical results revealed two different regimes over the spacing range. The drag force on the downstream cylinder was negative for all corner radii values when the cylinders were placed at L/D = 3.0 (a single-body system). Subsequently, a sudden increase was observed in the aerodynamic forces (drag and lift) when L/D increased. A different gap value was identified in the transformation from a single-body to a two-body system for different corner radii. To verify the single-body system, a simulation was carried out with a single cylinder having a longitudinal geometric dimension equal to the tandem arrangement (L/D + D). Furthermore, in a single-body regime, the total drag of a tandem cylinder was less than that of a single cylinder, thus demonstrating the benefits of using tandem structures. A significant reduction in the aerodynamic forces and drag force was achieved by rounding the sharp corners and placing the cylinders in close proximity. An appropriate configuration of the tandem cylinders with a rounded corner of R/D = 0.4 and 0.5 at L/D = 3.0 and the range is enhanced to L/D = 4.0 for 0.0 ≤ R/D < 0.4 to achieve adequate drag reduction. Originality/value: To the best of the author’s knowledge, there is a paucity of studies examining the effect of corner radius on bluff bodies arranged in a tandem configuration.