Abstract
The microstructural characteristics, tensile properties and low-cycle fatigue properties of a dual-phase steel (DP780) were investigated following its joining by three methods: laser welding, tungsten inert gas (TIG) welding, and metal active gas (MAG) welding. Through this, it was found that the size of the welded zone increases with greater heat input (MAG. >. TIG. >. laser), whereas the hardness of the weld metal (WM) and heat-affected zone (HAZ) increases with cooling rate (laser. >. TIG. >. MAG). Consequently, laser- and TIG-welded steels exhibit higher yield strength than the base metal due to a substantially harder WM. In contrast, the strength of MAG-welded steel is reduced by a broad and soft WM and HAZ. The fatigue life of laser-and TIG-welded steel was similar, with both being greater than that of MAG-welded steel; however, the fatigue resistance of all welds was inferior to that of the non-welded base metal. Finally, crack initiation sites were found to differ depending on the microstructural characteristics of the welded zone, as well as the tensile and cyclic loading.
| Original language | English |
|---|---|
| Pages (from-to) | 559-565 |
| Number of pages | 7 |
| Journal | Materials and Design |
| Volume | 64 |
| DOIs | |
| State | Published - 1 Dec 2014 |
Keywords
- Dual-phase steel
- Fatigue
- Laser welding
- Metal active gas welding
- Tensile properties
- Tungsten inert gas welding